With the i539's friends will have a feeling, that is, the battery Laptop Battery standby is not very satisfactory, although the standby power can also be thick, but thick, after all, and little influence beautiful, but also in everyday use is also very convenient, especially in summer is coming, and equipment In the trouser pocket where the total not the case, although the thin 1000 milliamperes of electricity, but only one, If we are able to have a lot of will be easy, but the original thin or not very good buying power, or high prices, physical in order to dilute the Guia, how should we do? The only ones to find ways to solve! )
The Trustee Lane a few today, Red Star brand commercial batteries, NOKIA8800, and 1200 milliamperes, and in fact 8800 1000 mAh PM579A battery is good business to buy, but the 1200 milliamperes of the too little (getting goods with prices of 22 per 1) , after thinking it over, due to the length of the relationship between the battery 539 has greatly affected the transformation of the play, the battery can only be transformed 8800
Talk about transformation prior to preparing tools: scalpel, 502 glue, double-sided adhesive, 20W electric soldering iron, solder, rosin, flat screwdriver, pliers, wire, multimeter, etc.
First, the 8800 battery stripped all the clothes,
Then, with the scalpel to Yi Bai 367759-001 batteries aside, this aspect is important to note, must be drawn slowly along the periphery 1.1 points, the first open-top, then open on both sides, and finally open the bottom, when the draw, after the gap, with little by little screwdriver pry a little harder, and then should be able to open.
Then come to see 8800's battery and the battery size comparison 539
Then, we will build 539 on a three finger with a hot iron removed, removed, the need to use pliers to cut the middle finger, or go down to 8800, when the battery coat will cause a short circuit has serious consequences!
Next, the battery can be welded onto the past, 8800, and note that we must separate the positive and negative, without the multimeter, see Figure
This contact directly to the right, and then the connection is wrong, and must be reversed connection, but, after all, the battery shell where space is limited, if they are directly reversed connection, then three finger can not be an accurate right to the shell on the vents and can only think of other ways you can look at dislocation to cheat to the left, fancy diagrams, the most under the PF723A right side of the finger to the far left of the battery contact 8800, and then most of the above there will be no finger location, and can only fly line, forcibly took the top of the finger connected to the 8800 battery on the far right contact, then with a hot iron can be welded on.
The following steps are paramount, and then the battery sealed with double-sided adhesive is good, all has to be closed, sealed, after the first paste it into a contact core-hole out of that face, paste after this, we must take into account contact at the contact problem, in the cheat back, must use a hard thing to pad up pads to just be able to cover the lid on the line, if handled badly, with double-sided tape to find space to adjust finished, put the lid fastened with glue 502 sealing, in this way, the battery was turned over to finished core.
After the transformation has affected the appearance of beautiful, but the Pavilion DV1000(hp dv1000 battery) battery is inside the use of deduction, and only when the charge will see that, after all, to turn over a stand-by time will be extended after the double transformation of 600 milliamperes before, now became a 1200 milli - An, practical ah, but low prices, while maintaining the same time the thickness of thin electric, battery capacity actually thinner than the original power for more than 200 milliamperes, I personally believe it is worth it
没有评论:
发表评论